CORRECT TEXT
You have been tasked with configuring multilayer SwitchC, which has a partial configuration and
has been attached to RouterC as shown in the topology diagram.

You need to configure SwitchC so that Hosts H1 and H2 can successfully ping the server
S1. Also SwitchC needs to be able to ping server S1.
Due to administrative restrictions and requirements you should not add/delete vlans or create
trunk links. Company policies forbid the use of static or default routing. All routes must be learned
via EIGRP 65010 routing protocol.
You do not have access to RouteC. RouterC is correctly configured. No trunking has been
configured on RouterC.
Routed interfaces should use the lowest host on a subnet when possible. The following subnets
are available to implement this solution:
– 10.10.10.0/24
– 190.200.250.32/27
– 190.200.250.64/27
Hosts H1 and H2 are configured with the correct IP address and default gateway.
SwitchC uses Cisco as the enable password.
Routing must only be enabled for the specific subnets shown in the diagram.
Note: Due to administrative restrictions and requirements you should not add or delete VLANs,
changes VLAN port assignments or create trunks. Company policies forbid the use of static or
default routing. All routes must be learned via the EIGRP routing protocol.

You have been asked to install and configure a new switch in a customer network. Use the
console access to the existing and new switches to configure and verify correct device
configuration.

You are connecting the New_Switch to the LAN topology; the switch has been partially configured
and you need to complete the rest of configuration to enable PC1 communication with PC2. Which
of the configuration is correct?

You have been asked to install and configure a new switch in a customer network. Use the
console access to the existing and new switches to configure and verify correct device
configuration.

Refer to the configuration. For which configured VLAN are untagged frames sent over trunk
between SW1 and SW2?

You have been asked to install and configure a new switch in a customer network. Use the
console access to the existing and new switches to configure and verify correct device
configuration.

You are adding new VLANs. VLAN500 and VLAN600 to the topology in such way that you need to
configure SW1 as primary root for VLAN 500 and secondary for VLAN 600 and SW2 as primary
root for VLAN 600 and secondary for VLAN 500. Which configuration step is valid?

You have been asked to install and configure a new switch in a customer network. Use the
console access to the existing and new switches to configure and verify correct device
configuration.

Examine the VTP configuration. You are required to configure private VLANs for a new server
deployment connecting to the SW4 switch. Which of the following configuration steps will allow
creating private VLANs?