Which set of commands changes the FTP client timeout when the sensor is communicating with an FTP server?
Which set of commands changes the FTP client timeout when the sensor is communicating with
an FTP server?
What is the maximum number of 10 Gigabit Ethernet connections that can be utilized in an EtherChannel for the
What is the maximum number of 10 Gigabit Ethernet connections that can be utilized in an
EtherChannel for the virtual switch link?
What are three attributes that can be applied to a user account with RBAC?
What are three attributes that can be applied to a user account with RBAC? (Choose three.)
what happens if all VSL connections between the virtual switch members are lost?
Which statement describes what happens if all VSL connections between the virtual switch
members are lost?
What are two benefits of using SPAN with promiscuous mode deployment?
What are two benefits of using SPAN with promiscuous mode deployment? (Choose two.)
what happens when a switch enters dual active recovery mode?
Which statement describes what happens when a switch enters dual active recovery mode?
which account has most likely been improperly modified?
If you encounter problems logging in to the Cisco Security Manager 4.4 web server or client or
backing up its databases, which account has most likely been improperly modified?
• SwitchB VTP mode needs to be the same as Switch
CORRECT TEXT
Scenario:
You work for SWITCH.com. They have just added a new switch (SwitchB) to the existing network
as shown in the topology diagram.
RouterA is currently configured correctly and is providing the routing function for devices on
SwitchA and SwitchB. SwitchA is currently configured correctly, but will need to be modified to
support the addition of SwitchB. SwitchB has a minimal configuration. You have been tasked with
competing the needed configuring of SwitchA and SwitchB. SwitchA and SwitchB use Cisco as the
enable password.
Configuration Requirements for SwitchA
The VTP and STP configuration modes on SwitchA should not be modified.
• SwitchA needs to be the root switch for vlans 11, 12, 13, 21, 22 and 23. All other vlans should
be left are their default values.
Configuration Requirements for SwitchB
• Vlan 21
Name: Marketing
will support two servers attached to fa0/9 and fa0/10
• Vlan 22
Name: Sales
– will support two servers attached to fa0/13 and fa0/14
• Vlan 23
o Name: Engineering
o will support two servers attached to fa0/15 and fa0/16
• Access ports that connect to server should transition immediately to forwarding state upon
detecting the connection of a device.
• SwitchB VTP mode needs to be the same as SwitchA.
• SwitchB must operate in the same spanning tree mode as SwitchA
• No routing is to be configured on SwitchB
• Only the SVI vlan 1 is to be configured and it is to use address 192.168.1.11/24
Inter-switch Connectivity Configuration Requirements
• For operational and security reasons trunking should be unconditional and Vlans 1, 21, 22 and
23 should tagged when traversing the trunk link.
• The two trunks between SwitchA and SwitchB need to be configured in a mode that allows for
the maximum use of their bandwidth for all vlans. This mode should be done with a nonproprietary protocol, with SwitchA controlling activation.
• Propagation of unnecessary broadcasts should be limited using manual pruning on this trunk
link.
What are the initial actions that can be performed on an incoming SMTP session by the workqueue of a Cisco Ema
What are the initial actions that can be performed on an incoming SMTP session by the
workqueue of a Cisco Email Security Appliance?
Which component does Cisco ASDM require on the host Cisco ASA 5500 Series or Cisco PIX security appliance?
Which component does Cisco ASDM require on the host Cisco ASA 5500 Series or Cisco PIX
security appliance?