What is the result of the implemented command?
Interface FastEthernet0/1 is configured as a trunk interface that allows all VLANs. This command
is configured globally:
monitor session 2 filter vlan 1 – 8, 39, 52
What is the result of the implemented command?
What is the default OSPF hello interval on a Frame Relay point-to-point network?
What is the default OSPF hello interval on a Frame Relay point-to-point network?
What step is required to enable HTTPS Proxy on the Cisco Web Security Appliance?
What step is required to enable HTTPS Proxy on the Cisco Web Security Appliance?
Which command only announces the 1.2.3.0/24 network out of FastEthernet 0/0?
Refer to the exhibit.
Which command only announces the 1.2.3.0/24 network out of FastEthernet 0/0?
What is the default behavior of an access list on the Cisco ASA security appliance?
What is the default behavior of an access list on the Cisco ASA security appliance?
Which prefix is matched by the command ip prefix-list name permit 10.8.0.0/16 ge 24 le 24?
Which prefix is matched by the command ip prefix-list name permit 10.8.0.0/16 ge 24 le 24?
What would cause the output to show only the single neighbor?
A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the
diagram that is provided. The engineer notices only a single neighbor that uses Cisco Discovery
Protocol, but it has several routing neighbor relationships. What would cause the output to show
only the single neighbor?
Why is the routing information not being learned by Router B?
Router A and Router B are configured with IPv6 addressing and basic routing capabilities using
OSPFv3. The networks that are advertised from Router A do not show up in Router B’s routing
table. After debugging IPv6 packets, the message “not a router” is found in the output. Why is the
routing information not being learned by Router B?
what do you conclude about these IPv6 addresses?
After you review the output of the command show ipv6 interface brief, you see that several IPv6
addresses have the 16-bit hexadecimal value of “FFFE” inserted into the address. Based on this
information, what do you conclude about these IPv6 addresses?
What is the expected acknowledgment and its usage?
A packet capture log indicates that several router solicitation messages were sent from a local
host on the IPv6 segment. What is the expected acknowledgment and its usage?