What does the log indicate?
A network engineer is troubleshooting a LAP that is unable to join the controller and receives the
message below:
LWAPP_CLIENT_ERROR_DEBUG. No more AP manager IP addresses remain
What does the log indicate?
what technology successfully resists interference by utilizing a wider bandwidth than needed for the transmitt
To implement a more secure means of communication for voice and data, what technology
successfully resists interference by utilizing a wider bandwidth than needed for the transmitting
signal?
What two interferers would likely be identified?
An 802.11g network is experiencing intermittent signal degradation and Spectrum Analyzer is
being used to try and locate the problem. What two interferers would likely be identified? (Choose
two.)
What organization is this?
A wireless bridge is being installed near an airport. An organization informs the city council about
complying with max power levels that could be used and settings on any 5GHz channels used that
might interfere with the airport radar. What organization is this?
What should the transmit power be set to?
An installation uses a 21dBi parabolic dish. It is connected to the 802.11n radio via low loss
antenna coax rated at 4dB loss/100 feet. After testing, it has been determined that 2mW of power
will be lost in the cable. An EIRP producing 200mW is desired. What should the transmit power be
set to?
What other antenna will produce a similar pattern?
An engineer is seeing a pattern closest to that of an Isotropic Radiator. What other antenna will
produce a similar pattern?
how does the traffic of each SSID reach the 802.3 network?
When using multiple SSIDs on a lightweight AP, how does the traffic of each SSID reach the 802.3
network?
what two design requirements must be met?
What 802.1x role is responsible for moving a port to the authorized state?
What 802.1x role is responsible for moving a port to the authorized state?
How many types of control frames are only used in PCF mode?
How many types of control frames are only used in PCF mode?