Refer to the exhibit. In the Frame Relay network, which IP addresses would be assigned to the
interfaces with point-to-point PVCs?

Based on the network shown in the graphic which option contains both the potential networking
problem and the protocol or setting that should be used to prevent the problem?

A network administrator needs to allow only one Telnet connection to a router. For anyone viewing
the configuration and issuing the show run command, the password for Telnet access should be
encrypted. Which set of commands will accomplish this task?

Refer to the exhibit. Which address and mask combination represents a summary of the routes
learned by EIGRP?

Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What
would be the most effective steps to troubleshoot this physical layer problem? (Choose three.)

Refer to the exhibit. A network administrator on workstation M uses Telnet to log in to the
command line interface of router A. The administrator wishes to discover information about active
workstations on the LAN attached to router A, including their IP and MAC addresses. Which
command will provide this information?

Refer to the exhibit. Configuration of both switches has been completed. During testing, the
network administrator notices that users on SwitchA can not connect with users in the same VLAN
on SwitchB. What should be done to solve this problem?

Refer to the exhibit. Based on the information given, which switch will be elected root bridge and
why?

Refer to the exhibit. S0/0 on R1 is configured as a multipoint interface to communicate with R2
and R3 in this hub-and-spoke Frame Relay topology. While testing this configuration, a technician
notes that pings are successful from hosts on the 172.16.1.0/24 network to hosts on both the
172.16.2.0/25 and 172.16.2.128/25 networks. However, pings between hosts on the 172.16.2.0/25
and 172.16.2.128/25 networks are not successful. What could explain this connectivity problem?