what does the 128 refer in the router output O 192.168.12.240/30 [110/128] via 192.168.12.233,00:35:36, Serial
Refer to the exhibit. To what does the 128 refer in the router output O 192.168.12.240/30
[110/128] via 192.168.12.233,00:35:36, Serial 0?
Which three of the following tools are required for camera alignment?
Which three of the following tools are required for camera alignment? (Choose three)
Which two statements are true about the loopback address that is configured on RouterB?
Refer to the exhibit. Which two statements are true about the loopback address that is configured
on RouterB? (Choose two.)
Which three statements are true about the Audio Extension Unit?
Which three statements are true about the Audio Extension Unit? (Choose three)
Which CTS endpoint allows you to choose the table type in the administration GUI?
Which CTS endpoint allows you to choose the table type in the administration GUI?
which two devices could be installed at the customer site to provide a connection through the local loop to th
Refer to the exhibit. The network administrator must complete the connection between the RTA of
the XYZ Company and the service provider. To accomplish this task, which two devices could be
installed at the customer site to provide a connection through the local loop to the central office of
the provider? (Choose two.)
What IP phone information is needed to register with Cisco Unified Communications Manager?
What IP phone information is needed to register with Cisco Unified Communications Manager?
Which of the following describe private IP addresses?
Which of the following describe private IP addresses? (Choose two.)
Where do you check the firmware code of the Primary Codec using the CTS Web GUI?
Where do you check the firmware code of the Primary Codec using the CTS Web GUI?
Which cable should you check to verify connection from the right camera to the Codec?
The right camera on a CTS-1300 is showing a red X in system status. The error is an Ethernet
error. Which cable should you check to verify connection from the right camera to the Codec?