What is the default syslog facility used to display log messages for a Cisco switch running Cisco IOS Software
What is the default syslog facility used to display log messages for a Cisco switch running Cisco
IOS Software Release 12.2.18(SXF)?
What is the reason that the interface status is "administratively down, line protocol down"?
Refer to the exhibit.
What is the reason that the interface status is “administratively down, line protocol down”?
Which of the following would allow the link to forward data traffic within a few seconds after bringing up bot
Refer to the exhibit.
A Cisco 7200 Series Router is directly connected to a Cisco Catalyst 3560 Series Switch over a
Gigabit Ethernet link. It takes an average of 50 seconds after bringing up both ends of the link for
data traffic to flow across the link. Which of the following would allow the link to forward data traffic
within a few seconds after bringing up both ends of the link?
What are two security appliances that can be installed in a network?
What are two security appliances that can be installed in a network? (Choose two.)
Which statement is true about this message?
While at the CLI on a Cisco ASR 9000 Series router, you notice the following message appear on
your screen:
2w6d: %SYS-5-CONFIG_I: Configured from console by cisco on vty0 (10.10.20.100)
Which statement is true about this message?
Which message will be returned from the receiver to the sender as part of this TCP/IP transfer?
A TCP/IP transfer is diagrammed in the exhibit.
A window size of three has been negotiated for this transfer. Which message will be returned from
the receiver to the sender as part of this TCP/IP transfer?
Which connections allow the use of full-duplex Ethernet?
Which connections allow the use of full-duplex Ethernet?(Choose three.)
Which tool enables this type of monitoring on a Cisco 7600 Series Router?
You need to monitor a connection between two PE routers for packet jitter and delay. Which tool
enables this type of monitoring on a Cisco 7600 Series Router?
Which two locations can be configured as a source for the IOS image in the boot system command?
Which two locations can be configured as a source for the IOS image in the boot system
command? (Choose two.)
What is the signaling protocol used by Cisco Unified Communications Manager to communicate with the Codec and
What is the signaling protocol used by Cisco Unified Communications Manager to communicate
with the Codec and IP Phone for Cisco TelePresence.