Which statements describe the routing protocol OSPF?
Which statements describe the routing protocol OSPF? (Choose three.)
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VL
Which protocol reduces administrative overhead in a switched network by allowing the
configuration of a new VLAN to be distributed to all the switches in a domain?
what configuration error is causing this problem?
A network administrator is trying to add a new router into an established OSPF network. The
networks attached to the new router do not appear in the routing tables of the other OSPF routers.
Given the information in the partial configuration shown below, what configuration error is causing
this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0
which two effects would it have on the network?
Refer to the exhibit. If switch SW2 was replaced with a router, which two effects would it have on
the network? (Choose two.)
which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s.
The addressing scheme for each company site is as follows:
Router Ethernet port – 1st usable address
Core – 2nd usable address
Core2 – 3rd usable address
For this network, which of the following commands must be configured on Core2 to allow it to be
managed remotely from any subnet on the network? (Choose three.)
what value does a router use for the OSPF router ID in the absence of a loopback interface?
If all OSPF routers in a single area are configured with the same priority value, what value does a
router use for the OSPF router ID in the absence of a loopback interface?
Which two connectivity options should the engineer use?
A network engineer has multiple network devices to choose from to connect 10 PCs to a network.
Requirements include that packet collisions are minimized for each client and that the physical
network topology must be highly scalable. Which two connectivity options should the engineer
use? (Choose two.)
which of the following tasks?
The OSPF Hello protocol performs which of the following tasks? (Choose two.)
What will the router do with this packet?
Refer to the output of the corporate router routing table shown in the graphic.
The corporate router receives an IP packet with a source IP address of 192.168.214.20 and a
destination address of 192.168.22.3. What will the router do with this packet?
what is the cause of this problem?
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The
routers cannot establish an adjacency relationship on their common Ethernet link. The graphic
shows the output of the show ip ospf interface e0 command for routers R1 and R2.
Based on the information in the graphic, what is the cause of this problem?