What is the purpose of Spanning Tree Protocol?
What is the purpose of Spanning Tree Protocol?
What is the command sequence to force a Cisco Nexus 6000 switch to boot using the golden BIOS image?
What is the command sequence to force a Cisco Nexus 6000 switch to boot using the golden
BIOS image?
Which statement describes DLCI 17?
what will Host1 do?
IP information
CORRECT TEXT
Lab- CLI
Central Florida Widgets recently installed a new router in their office. Complete the network
installation by performing the initial router configurations and configuring R1PV2 routing using the
router command line interface (CLI) on the RC.
Configure the router per the following requirements:
Name of the router is R2
Enable. secret password is cisco
The password to access user EXEC mode using the console is cisco2
The password to allow telnet access to the router is cisco3
IPV4 addresses mast be configured as follows:
Ethernet network 209.165.201.0/27 – router has fourth assignable host address in subnet
Serial network is 192.0.2.176/28 – router has last assignable host address in the subnet.
Interfaces should be enabled.
Router protocol is RIPV2
Attention:
In practical examinations, please note the following, the actual information will prevail.
1. Name of the router is xxx
2. Enable. secret password is xxx
3. Password In access user EXEC mode using the console is xxx
4. The password to allow telnet access to the router is xxx
5. IP information
Which procedure is used to download a new kickstart image?
The kickstart image is corrupted on a Cisco Nexus 7000 switch. Which procedure is used to
download a new kickstart image?
which address?
On point-to-point networks, OSPF hello packets are addressed to which address?
Why are these switches not sharing VTP messages?
which layer of the OSI model does the problem most likely exist?
While troubleshooting a network connectivity problem, a technician observes steady link lights on
both the workstation NIC and the switch port to which the workstation is connected. However,
when the ping command is issued from the workstation, the output message “Request timed out.”
is displayed. At which layer of the OSI model does the problem most likely exist?