Which destination addresses will Host A use to send data to Host B?
Refer to the exhibit. Which destination addresses will Host A use to send data to Host B? (Choose
two.)
Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy?
The network security policy requires that only one host be permitted to attach dynamically to each
switch interface. If that policy is violated, the interface should shut down. Which two commands
must the network administrator configure on the 2950 Catalyst switch to meet this policy? (Choose
two.)
Which commands will accomplish this?
Refer to the graphic. A static route to the 10.5.6.0/24 network is to be configured on the HFD
router. Which commands will accomplish this? (Choose two.)
which type of connector is used?
When deploying 10BASE-2 Ethernet, which type of connector is used?
What should be done prior to backing up an IOS image to a TFTP server?
What should be done prior to backing up an IOS image to a TFTP server? (Choose three.)
Which are valid modes for a switch port used as a VLAN trunk?
Which are valid modes for a switch port used as a VLAN trunk? (Choose three.)
Which of the following IP addresses can be assigned to hosts in the third subnet if the ip subnet-zero command
The network 172.25.0.0 has been divided into eight equal subnets. Which of the following IP
addresses can be assigned to hosts in the third subnet if the ip subnet-zero command is
configured on the router? (Choose three.)
what is the maximum cable length?
When deploying 10BASE-2 Ethernet, what is the maximum cable length?
what is wrong with the IP configuration information shown?
Refer to the graphic. Host 1 cannot receive packets from Host 2. Assuming that RIP v1 is the
routing protocol in use, what is wrong with the IP configuration information shown? (Choose two.)
What are three valid reasons to assign ports to VLANs on a switch?
What are three valid reasons to assign ports to VLANs on a switch? (Choose three.)