which of the following subnet masks will support an appropriate addressing scheme?
A national retail chain needs to design an IP addressing scheme to support a nationwide network.
The company needs a minimum of 300 sub-networks and a maximum of 50 host addresses per
subnet. Working with only one Class B address, which of the following subnet masks will support
an appropriate addressing scheme? (Choose two.)
which of the following are valid host addresses on this subnet?
Given the address 192.168.20.19/28, which of the following are valid host addresses on this
subnet? (Choose two.)
What types of packets will be permitted by this ACL?
An inbound access list has been configured on a serial interface to deny packet entry for TCP and
UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL? (Choose three.)
which are valid modes for a switch port used as a VLAN trunk?
As a network technician, do you know which are valid modes for a switch port used as a VLAN
trunk? (Choose three.)
Which option would you use to exit the Cisco Nexus Operating System interface configuration mode and return to
Which option would you use to exit the Cisco Nexus Operating System interface configuration
mode and return to the exec prompt?
What are the characteristics of OSPF areas?
OSPF routing uses the concept of areas. What are the characteristics of OSPF areas? (Choose
Three.)
What information can be used by a router running a link-state protocol to build and maintain its topological d
What information can be used by a router running a link-state protocol to build and maintain its
topological database? (Choose two.)
Which items are correct about the routing protocol OSPF?
Which items are correct about the routing protocol OSPF? (Choose three.)
What is the correct format of an access control list on a Cisco Nexus switch to deny unencrypted Web traffic f
What is the correct format of an access control list on a Cisco Nexus switch to deny unencrypted
Web traffic from any source to destination host 10.10.1.110?
which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet
The switches shown in the diagram.
Core and Core2, are both Catalyst 2950s.
The addressing scheme for each company site is as follows:
Router Ethernet port: 1st usable address
CorE. second usable address
Core2: third usable address
For this network, which of the following commands must be configured on Core2 to allow it to be
managed remotely from any subnet on the network? (Choose three.)
