Which configuration is the correct Cisco IOS configuration that corresponds to the Cisco SAF Forwarder that is
What is the reason that an outgoing call succeeds when there is no COR list that is applied to the incoming di
What is the reason that an outgoing call succeeds when there is no COR list that is applied to the
incoming dial peer and a COR list is applied to the outgoing dial peer?
which minimum configuration would be needed on Cisco Unified Communications Manager to test registration?
Cisco Unified Communications Manager failed to register with the Cisco SAF Forwarder.
Assuming that the Cisco IOS SAF Forwarder is configured correctly, which minimum configuration
would be needed on Cisco Unified Communications Manager to test registration?
Which two types of Cisco Unified Communications Manager trace files contain Call Processing information that i
Which two types of Cisco Unified Communications Manager trace files contain Call Processing
information that is helpful for troubleshooting outbound and inbound calling issues?
(Choose two)
What is the reason that an outgoing call succeeds when COR is applied to the incoming dial peer, but no COR is
What is the reason that an outgoing call succeeds when COR is applied to the incoming dial peer,
but no COR is applied to the outgoing dial peer?
which four actions can resolve this issue?
Refer to the exhibit.
The exhibit shows the output of debug isdn q931. An inbound PSTN call was received by an
H.323 gateway that is configured in Cisco Unified Communications Manager. The call failed to ring
extension 3001. If the phone at extension 3001 is registered and reachable through the gateway
inbound CSS, which four actions can resolve this issue? (Choose four.)
which dialed digits are being sent to the PSTN?
Calls are failing to egress the local PSTN gateway that uses an E1 PRI circuit. Which debug
command would be most useful in determining which dialed digits are being sent to the PSTN?
Which course of action would rectify this issue?
Refer to the exhibit.
Assume a centralized Cisco Unified Communications Manager topology. From the output of the
show policy-map interface command, it can be seen that the voice traffic is experiencing drops.
The router is configured for low latency queuing and is located at the central site. Which course of
action would rectify this issue?