After the recent upgrade of the switching infrastructure, the network engineer notices that the port roles that were once “blocking” are now defined as “alternate” and
“backup.” What is the reason for this change?

Refer to the exhibit.

Switch A, B, and C are trunked together and have been properly configured for VTP. Switch B has all VLANs, but Switch C is not receiving traffic from certain
VLANs. What would cause this issue?

Refer to the exhibit.

Switch A, B, and C are trunked together and have been properly configured for VTP. Switch C receives VLAN information from the VTP server Switch A, but Switch
B does not receive any VLAN information. What is the most probable cause of this behavior?

After implementing VTP, the extended VLANs are not being propagated to other VTP switches.
What should be configured for extended VLANs?

Several new switches have been added to the existing network as VTP clients. All of the new switches have been configured with the same VTP domain, password,
and version. However, VLANs are not passing from the VTP server (existing network) to the VTP clients. What must be done to fix this?

After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco
Discovery Protocol are not visible. Which vendor-neutral protocol could be used to resolve this issue?

A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided. The engineer notices only a single neighbor
that uses Cisco Discovery Protocol, but it has several routing neighbor relationships. What would cause the output to show only the single neighbor?

Interface FastEthernet0/1 is configured as a trunk interface that allows all VLANs. This command is configured globally:
monitor session 2 filter vlan 1 8, 39, 52
What is the result of the implemented command?

An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the
EtherChannel links is being utilized to reach the web server. What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate
web server?

After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in the down/down state. Switch A is configured with channel-group 1
mode active, while Switch B is configured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working?