which that route originated?
A rogue static route is installed in the routing table of a Cisco FlexVPN and is causing traffic to be
blackholed. Which command should be used to identify the peer from which that route originated?
Which RAS message is used between two gatekeepers to resolve an alias address?
Which RAS message is used between two gatekeepers to resolve an alias address?
Which authentication method was used by the remote peer to prove its identity?
Refer to the exhibit.
Which authentication method was used by the remote peer to prove its identity?
what is the first step it will take in an attempt to resolve the destination address?
When a Cisco IOS gatekeeper receives an ARQ from a registered endpoint, what is the first step it
will take in an attempt to resolve the destination address?
Which configuration error is causing the failure?
Refer to the exhibit.
An IPsec peer is exchanging routes using IKEv2, but the routes are not installed in the RIB. Which
configuration error is causing the failure?
Which configuration needs to be added or changed?
Refer to the exhibit.
An administrator is adding IPv6 addressing to an already functioning tunnel. The administrator is
unable to ping 2001:DB8:100::2 but can ping 209.165.200.226. Which configuration needs to be
added or changed?
what is the first step it will take in an attempt to resolve the destination address?
When a Cisco IOS gatekeeper receives an LRQ, what is the first step it will take in an attempt to
resolve the destination address?
Which action will allow the session to establish correctly?
Refer to the exhibit.
The IKEv2 tunnel between Router1 and Router2 is failing during session establishment. Which action
will allow the session to establish correctly?
What does this output suggest?
You are troubleshooting a site-to-site VPN issue where the tunnel is not establishing. After issuing
the debug crypto isakmp command on the headend router, you see the following output. What does
this output suggest?
1d00h: ISAKMP (0:1): atts are not acceptable. Next payload is 0
1d00h: ISAKMP (0:1); no offers accepted!
1d00h: ISAKMP (0:1): SA not acceptable!
1d00h: %CRYPTO-6-IKMP_MODE_FAILURE. Processing of Main Mode failed with peer at 10.10.10.10
Which ITU-T recommendation defines the procedures for using more than one video channel in
Which ITU-T recommendation defines the procedures for using more than one video channel in