Which two statements are correct for a safe wiring inst…
Exhibit:
Which two statements are correct for a safe wiring installation to the terminal block of the switch or
endpoint? (Choose two.)
What are three traffic and interconnection requirements…
Exhibit:
Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit?
(Choose three.)
Which option allows an EtherNet/IP I/O device to be saf…
Which option allows an EtherNet/IP I/O device to be safely installed where it is subject to water immersion?
Which port should a PLC with IP address 192.168.3.65 be…
Exhibit:
Refer to the exhibit. Which port should a PLC with IP address 192.168.3.65 be plugged into in order to
communicate to the rest of the network?
Which of the following correctly pairs the dotted decim…
Which of the following correctly pairs the dotted decimal subnet mask with the correct number of binary bits
that represent the subnet mask?
What action will accomplish this task?
A network engineer wants to make sure that an access switch will never become a Spanning Tree root for VLAN 5. What action will accomplish this task?
Which action accomplishes this task?
An access switch at a remote location is connected to the spanning-tree root with redundant uplinks. A network engineer notices that there are issues with the
physical cabling of the current root port. The engineer decides to force the secondary link to be the desired forwarding root port.
Which action accomplishes this task?
Which two options are two results of using the command …
Which two options are two results of using the command spanning-tree vlan 50 root primary within a spanning-tree network under global configuration? (Choose
two.)
What is wrong with the configuration?
Refer to the exhibit.
A network engineer changes the default native VLAN to VLAN 999. After applying the settings on the uplinks to the core switches, the switch control traffic, such as
CDP and VTP, is no longer working. The standard configuration is used for each uplink. What is wrong with the configuration?
Drag and drop the characteristic from the left…
DRAG DROP
Drag and drop the characteristic from the left to the matching Layer 2 protocol on the right.
