what is the User Datagram Protocol (UDP) idle time set for any HTTP traffic that is sourced from the "in&
Refer to the appropriate SDM screen(s), what is the User Datagram Protocol (UDP) idle time set
for any HTTP traffic that is sourced from the “in” zone and destined to the “out” zone?
which function?
When you configure Cisco IOS WebVPN, you can use the port-forward command to enable which
function?
Which type of privileges must you have on a host system to install CSA?
Which type of privileges must you have on a host system to install CSA?
Which two statements are correct?
Refer to the DMVPN topology diagram in the exhibit. Which two statements are correct? (Choose
two.)
Why is auth-proxy not working?
Refer to the exhibit. Why is auth-proxy not working?
what is the reason that outside hosts can’t initiate Telnet (port 23) traffic to the 172.16.1.10 inside
Refer to the appropriate SDM screen(s), what is the reason that outside hosts can’t initiate Telnet
(port 23) traffic to the 172.16.1.10 inside host?
Which two statements are true regarding classic Cisco IOS Firewall configurations?
Which two statements are true regarding classic Cisco IOS Firewall configurations? (Choose two.)
how to configure the clientless SSL VPN portal?
The IT department of your company must perform a custom-built TCP application within the
clientless SSL VPN portal configured on your Cisco ASA security appliance. The application
should be run by users who have either guest or normal user mode privileges. In order to allow
this application to run, how to configure the clientless SSL VPN portal?
Which of the following predefined administrators allows the administrator all rights except SNMP access?
Which of the following predefined administrators allows the administrator all rights except SNMP
access?
Select the correct action, source and destination address for this policy.
In the diagram, the firewall feature was enabled on the VPN Client. By clicking on the Firewall tab
of the VPN Client connection status window, you can view the VPN Client’s firewall policy for the
four connection types, labeled 1 through 4 in the diagram. In the bottom half of the diagram,
Connection 4 displays the default policy applied to traffic which did not match the preceding three
policy statements, connection 1-3. For the default policy, any inbound traffic from source address
X and any local outbound traffic returning to its destination address X will have action Y applied to
this traffic. Select the correct action, source and destination address for this policy.
