Refer to the exhibit. Customer XYZ is using an MPLS VPN to connect its locations of Site_A,
Site_B, and
Site_C. Each site uses OSPF as the CE-PE routing protocol. After a new direct 56 kbps link was
added
between Site_A and Site_B, all applications degraded in response time only between Site_A and
Site_B. What is the most probable cause and its solution?
Exhibit:

DRAG DROP
Look at the picture.
Drag and drop the correct commands in the proper order to redistribute the RED VPN routes from the EIGRP vrf into the BGP vrf.

When configuring Internet access using a separate MPLS VPN, which three statements are
correct? (Choose three.)

When configuring Internet access from a MPLS VPN using a separate subinterface, which two
configurations are required on the PE router? (Choose two.)

What is the purpose of the global configuration command, ip dhcp relay information option vpn?

Using MPLS unicast IP forwarding, what will happen if an LSR receives an unlabeled incoming
packet?

When routes between MP-BGP and RIP are being redistributed, what does the option metric
transparent do?

For which purpose is the command mpls ldp maxhops used?

What is wrong with the following MP-BGP to EIGRP route redistribution configuration?
router eigrp 100

address-family ipv4 vrf XYZ
autonomous-system 200
redistribute bgp 51001

DRAG DROP
Drag the description on the left to the name of the table on the right to which it best corresponds.
Look at the picture.