DRAG DROP
Drag the term on the left to its definition on the right.

DRAG DROP
Drag each description on the left to the appropriate term on the right.

The following configuration is applied to a Layer 2 Switch:
interface fastethernet 0/4
switchport mode access
switchport port-security
switchport port-security mac-address 0000.1111.1111
switchport port-security maximum 2
swithcport port-security
What is the result of the above configuration being applied to the switch?

Which of these correctly describes the results of port security violation of an unknown packet?

Refer to the exhibit.

What three actions will the switch take when a frame with an unknown source MAC address arrives
at the interface? (Select three.)

Refer to the exhibit.

Assuming that the entire network topology is shown, what is the operational status of the interfaces
of R2 as indicated by the command output shown?

Refer to the exhibit.

Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output
from RouterA, what are two possible reasons for the failure? (Choose two.)

OSPF is configured using default classful addressing. With all routers and interfaces operational, how
many networks will be in the routing table of R1 that are indicated to be learned by OSPF?

After the network has converged, what type of messaging, if any, occurs between R3 and R4?

To allow or prevent load balancing to network 172.16.3.0/24, which of the following commands
could be used in R2? (Choose two.)