Refer to the exhibit.

Which two statements are true about the loopback address that is configured on RouterB? (Choose
two.)

What is the default maximum number of equal-cost paths that can be placed into the routing table
of a Cisco OSPF router?

Which parameter would you tune to affect the selection of a static route as a backup, when a
dynamic protocol is also being used?

What are two drawbacks of implementing a link-state routing protocol? (Choose two.)

Which two are advantages of static routing when compared to dynamic routing? (Choose two.)

A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default
characteristics. Each process learns a route to the same remote network.
If there are no static routes to the destination and none of the routes were redistributed, which
route will be placed in the IP routing table?

Refer to the exhibit.

Given the output for this command, if the router ID has not been manually set, what router ID will
OSPF use for this router?

The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the
graphic. There is concern that a lack of router resources is impeding internetwork performance. As
part of examining the router resources, the OSPF DRs need to be known. All the router OSPF
priorities are at the default and the router IDs are shown with each router.

Which routers are likely to have been elected as DR? (Choose two.)

What does a router do if it has no EIGRP feasible successor route to a destination network and the
successor route to that destination network is in active status?

Refer to the exhibit.

The network is converged. After link-state advertisements are received from Router_A, what
information will Router_E contain in its routing table for the subnets 208.149.23.64 and
208.149.23.96?