A network associate is adding security to the configuration of the Corp1 router. The user on
host C should be able to use a web browser to access financial information from the Finance
Web Server. No other hosts from the LAN nor the Core should be able to use a web browser
to access this server. Since there are multiple resources for the corporation at this location
including other resources on the Finance Web Server, all other traffic should be allowed.
The task is to create and apply an access-list with no more than three statements that will
allow ONLY host C web access to the Finance Web Server. No other hosts will have web
access to the Finance Web Server. All other traffic is permitted.
Access to the router CLI can be gained by clicking on the appropriate host.
All passwords have been temporarily set to “cisco”.
The Core connection uses an IP address of 198.18.196.65
The computers in the Hosts LAN have been assigned addresses of 192.168.33.1 –
192.168.33.254
Host A 192.168.33.1
Host B 192.168.33.2
Host C 192.168.33.3
Host D 192.168.33.4
The servers in the Server LAN have been assigned addresses of 172.22.242.17 –
172.22.242.30
The Finance Web Server is assigned an IP address of 172.22.242.23.

Which statement about access lists that are applied to an interface is true?

Which item represents the standard IP ACL?

A network administrator is configuring ACLs on a Cisco router, to allow traffic from hosts on
networks 192.168.146.0, 192.168.147.0, 192.168.148.0, and 192.168.149.0 only. Which two
ACL statements, when combined, would you use to accomplish this task? (Choose two.)

What can be done to secure the virtual terminal interfaces on a router? (Choose two.)

Which two commands correctly verify whether port security has been configured on port
FastEthernet 0/12 on a switch? (Choose two.)

Refer to the exhibit.

The following commands are executed on interface fa0/1 of 2950Switch.
2950Switch(config-if)# switchport port-security
2950Switch(config-if)# switchport port-security mac-address sticky
2950Switch(config-if)# switchport port-security maximum 1
The Ethernet frame that is shown arrives on interface fa0/1. What two functions will occur
when this frame is received by 2950Switch? (Choose two.)

What will be the result if the following configuration commands are implemented on a Cisco
switch?
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security mac-address sticky

Refer to the exhibit.

A network administrator attempts to ping Host2 from Host1 and receives the results that are
shown. What is the problem?

DRAG DROP
Drag each procedure on the left to its proper category on the right.