Refer to the exhibit.

A network administrator is troubleshooting a multicast problem in a Cisco Unified Wireless Network
topology. Which one of these groups of characteristics best describes the output shown in the
exhibit?

Which one of these options is not a valid reason for a client to become excluded?

Refer to the exhibit.

The corporate office has mandated that all guest WLAN users should have a per-user bandwidth
restriction. The requirement is 1 Mb/s for normal rate with a peak of 1.2 Mb/s. This is to be set for
HTTP traffic only. From the exhibit, showing the QoS properties for a current guest user connection,
is the above requirement met?

Refer to the exhibit.

A network administrator is troubleshooting a client connection and runs a debug client command on
the device MAC address. From the information in the exhibit, which explanation is correct?

Refer to the exhibit.

The customer intermittently sees these messages in the WLC message logs. Which two sentences
describe what these messages indicate? (Choose two.)

You are configuring WLC high availability for an access point. Which statement is true?

Refer to the exhibit.

A network administrator is troubleshooting a client connection problem. In the process of collecting
information, a client debug is run on the controller for the device MAC address. What is the most
likely cause of the problem?

A network administrator is troubleshooting a problem of a CAPWAP access point that intermittently
disconnects from the WLC . The administrator is trying to determine when the problem is happening.
UDP port 514 is allowed. What is the best option for successfully gathering comprehensive
information about the problem?

Refer to the exhibit.

You are testing the mesh AP feature in your lab. You begin by changing the AP mode from local to
bridge on one of your Cisco 3500 Series APs. The AP reboots and attempts to rejoin the controller,

but it fails to do so. Based upon the information in the exhibit, which two of these options would
allow the AP to join the WLC? (Choose two.)

Refer to the exhibit.

A network administrator is configuring and installing an indoor mesh network using two CAPWAP
APs. The APs were out of the box and have already been installed in their designated locations. The
RAP is joined to the controller and configured appropriately, but the MAP is not visible on the WLC.
In the output shown, which of these explanations is the most likely reason for the issue?