What is the correct command to upgrade an autonomous AP to a Cisco Unified AP (Cisco IOS Release
12.3(8)JEA2), after you established console access to the AP and set up a TFTP server at 1.1.1.1?

You are configuring an access point in a mobile scenario (on a train) which is connected to a L2
switch that has multiple clients attached. The access point must be configured to connect to the
mesh network. Which two of the below bridge configuration settings need to be configured?
(Choose two.)

Refer to the exhibit.

What does the max-channel 30 command refer to?

You are deploying a Cisco DMP (Digital Media Player) that only has an Ethernet interface, and you
plan to plug it into an access point to connect it to the Cisco Unified Wireless Network. The DMP
multicast video is displaying distorted and pixelated video. Which one of these radio interface
actions is most likely to improve the video stream quality?

Refer to the exhibit.

The autonomous AP has a corporate and guest SSID configured. The security team requested that
you limit guest user traffic to DHCP, DNS, and web browsing on the AP. Which configuration best
satisfies the request?

In the Cisco Unified Wireless Network (CUWN) model, which of the following mappings is correct at
the AP level?

You enabled CAC on your autonomous AP. Which two of these statements are true? (Choose two.)

A network administrator is trying to convert a Cisco Aironet 1250 Series Lightweight Access Point
back to autonomous mode using a TFTP server and AP mode button. DHCP Option 43 is configured,
but the AP is not connected to the controller. Console and physical access to the AP has been
established. The TFTP server is local to the PC and the directory has the original image of “c1250-
k9w7-tar.124-10b.JDA3.tar,” downloaded from Cisco.com. The PC is directly connected to the access
point, but the conversion is failing. Which one of these statements is a possible reason for the
failure?

Company XYZ needs to establish network connectivity to a newly acquired, adjacent building less
than 1 kilometer (3280 feet) away. The project calls for implementing a wireless solution using
autonomous access points in a point-to-point bridging solution using external antennas on interface
dot11radio1. You need to secure the bridge link with strong EAP, DOT1x, and WPA methods, using a
local RADIUS server. However, the link cannot be established and the following message is observed
in the logs: “DOT1X_SHIM-3-SUPP_START_FAIL: Unable to start supplicant on Dot11Radio1.” What is
most likely the root cause?

Company ABC is implementing a point-to-point bridging solution to a building approximately 3
kilometers (1.86 miles) away. The equipment used will be two autonomous access points set to
frequency 2412 Mhz with external antennas. The bridge link will be authenticated using an external
RADIUS server. While looking at the interface statistics, the network administrator observes
duplicate frames in the receive counters. What is most likely the root cause of these duplicate
frames?