Refer to the exhibit.

You are testing coverage-hole detection in your lab. You are using the default Cisco WLC coveragehole detection configuration that is shown. You have 14 test clients, all associated to the same AP.
You move three of the clients far away from the AP so that they have an RSSI of -85 dBm or lower for
1 minute. To your surprise, you see precoverage-hole alarms, but no coveragehole alarm is
triggered. Which two scenarios explain this issue? (Choose two.)

A wireless ISP has hired you to help set up a new Cisco WLC to provide wireless access to
subscription-based customers. Each customer that uses the wireless network needs to pay their bill
every 30 days. How do you configure the WLAN security to help meet this requirement?

When is the Poor Link SNR Alarm generated in a mesh network?

The helpdesk is reporting that many users are reporting slow wireless connections in one of the
office buildings. You look at the CleanAir statistics and do not see any interferers, but you see very
high 2.4-GHz channel utilization from the Wi-Fi devices. WCS is reporting the following mix of 802.11
chipsets in the building: 10 percent 802.11b, 75 percent 802.11g and 15 percent 802.11a. You do a
survey and see that you have a very dense deployment of APs and a lot of co-channel interference.
Which two steps would help lower your channel utilization in this area? (Choose two.)

A 7-Mb multicast traffic stream is being sent to wireless clients and it is using up most of the
available wireless spectrum in the 2.4-GHz unlicensed band. As a result, many of the data
applications have become sluggish and the video is choppy. What is the best option to send the
multicast over the wireless network more efficiently and leave some bandwidth for the data
applications (assuming the network is capable of supporting this option)?

Which two statements about virtual interfaces on a WLC are true? (Choose two.)

Refer to the exhibit.

Which EAP type does the diagram illustrate?

Which statement describes the operation of an access point in Rogue Location Discovery Protocol
mode?

Refer to the exhibit.

You want to use 3500e APs to setup an indoor mesh deployment. After you change the AP mode,
the AP will not rejoin the Cisco WLC. Which debug command was run, according to the exhibit, and
why is the AP not rejoining the Cisco WLC?

When you configure channel bonding on your APs by using the 2.4-GHz radio, what is the maximum
number of APs that you can place in a given location so that the AP channels do not overlap?