SIMULATION
Scenario:
You work for SWITCH.com. They have just added a new switch (SwitchB) to the existing
network as shown in the topology diagram.
RouterA is currently configured correctly and is providing the routing function for devices on
SwitchA and SwitchB. SwitchA is currently configured correctly, but will need to be modified
to support the addition of SwitchB. SwitchB has a minimal configuration. You have been
tasked with competing the needed configuring of SwitchA and SwitchB. SwitchA and
SwitchB use Cisco as the enable password.
Configuration Requirements for SwitchA
The VTP and STP configuration modes on SwitchA should not be modified.
• SwitchA needs to be the root switch for vlans 11, 12, 13, 21, 22 and 23. All other vlans
should be left are their default values.
Configuration Requirements for SwitchB
•Vlan 21
o Name: Marketing
owill support two servers attached to fa0/9 and fa0/10
•Vlan 22
oName: Sales
owill support two servers attached to fa0/13 and fa0/14
•Vlan 23
o Name: Engineering
o will support two servers attached to fa0/15 and fa0/16
•Access ports that connect to server should transition immediately to forwarding state upon
detecting the connection of a device.
•SwitchB VTP mode needs to be the same as SwitchA.
•SwitchB must operate in the same spanning tree mode as SwitchA
•No routing is to be configured on SwitchB
•Only the SVI vlan 1 is to be configured and it is to use address 192.168.1.11/24

Inter-switch Connectivity Configuration Requirements
•For operational and security reasons trunking should be unconditional and Vlans 1, 21, 22
and 23 should tagged when traversing the trunk link.
•The two trunks between SwitchA and SwitchB need to be configured in a mode that allows
for the maximum use of their bandwidth for all vlans. This mode should be done with a nonproprietary protocol, with SwitchA controlling activation.
•Propagation of unnecessary broadcasts should be limited using manual pruning on this
trunk link.

Given the configurations on SwitchA and SwitchB, which statement is true?

DRAG DROP
Drag the attributes on the left to the types of VLAN designs that they describe on the right.

Given the configurations on SwitchA and SwitchB, which two statements are true? (Choose
two.)

A network administrator enters the following switch commands:
Switch(config)#interface range fa0/0-5
Switch(config-if-range)#switchport access vlan 2
What is the result of these commands?

When a VLAN port configured as a trunk receives an untagged frame, what will happen?

By default, which statement is correct when an IEEE 802.1Q trunk port receives an
untagged frame?

Refer to the exhibit.

What information can be derived from the output?

What are three results of issuing the switchport host command? (Choose three.)

Refer to the exhibit.

All links in this network are layer 2, fast Ethernet 100 Mb/s and operating as trunks. After a
failure, the link between ASW-1 and DSW-1 has incorrectly come back up at 10Mb/s
although it is connected.

Which one of the following will occur as a result of this failure?