Which three characteristics are true about voice traffic in the campus network? (Choose
three.)

You have noticed a large number of topology changes in the Rapid Spanning Tree Protocol
network. Which statement is true about RSTP topology changes?

Refer to the exhibit.

The link between switch SW1 and switch SW2 is configured as a trunk, but the trunk failed to
establish connectivity between the switches. Based on the configurations and the error
messages received on the console of SW1, what is the cause of the problem?

When you create a network implementation for a VLAN solution, what is one procedure that
you should include in your plan?

HOTSPOT

DRAG DROP
Drag the questions that you would ask the network administrator before you start the planning from the left to the right.

DRAG DROP
Drag the choices on the left to the boxes on the right that should be included when creating a VLAN-based implementation plan. Not all choices will be used.

DRAG DROP
Drag each name from the left to the right.

Refer to the exhibit.

For the configuration shown, which is the recommended method of providing interVLAN
routing?

SIMULATION
You have been tasked with configuring multilayer SwitchC, which has a partial configuration
and has been attached to RouterC as shown in the topology diagram.

You need to configure SwitchC so that Hosts H1 arid H2 can successful ping the server S1.
Also SwitchC needs to be able to ping server SI.
Due to administrative restrictions and requirements you should not add/delete vlans or
create trunk links Company policies forbid the use of static or default routing All routes must
be learned via EIGRP 65010 routing protocol.
You do not have access to RouteC, RouterC is correctly configured. No trunking has been
configured on RouterC.
Routed interfaces should use the lowest host on a subnet when possible. The following
subnets are available to implement this solution:
• 172.16.1.0/24
• 192.168.3.32/27
• 192.168.3.64/27
Hosts H1 and H2 are configured with the correct IP address and default gateway.
SwitchC uses Cisco as the enable password.
Routing must only be enabled for the specific subnets shown in the diagram.
Note: Due to administrative restrictions and requirements you should not add or delete
VLANs, changes VLAN port assignments or create trunks. Company policies forbid the use
of static or default routing. All routes must be learning via the EIGRP routing protocol.

HOST 1

HOST 2