You want to configure a switched internetwork with multiple VLANs as shown above.
Which of the following commands should you issue on SwitchA for the port connected to
SwitchB? (Select the best answer.)

You administer the network shown above. You issue the show interfaces trunk command on
SwitchA and receive the following output:
SwitchA#show interfaces trunk
Port Mode Encapsulation Status Native vlan
Fa0/1 desirable -n802.1q trunking 1
Port Vlans allowed on trunk
Fa0/1 1-4094
Port Vlans allowed and active in management domain
Fa0/1 1-9, 31-37
Port Vlans in spanning tree forwarding state and not pruned
Fa0/1 1-9, 31, 33-37
Which of the following statements is true regarding VLAN 32? (Select the best answer.)

Which of the following HSRP router states does an active router enter when it is preempted
by a higher priority router? (Select the best answer.)

Which of the following will generate an RSTP topology change notification? (Select the best
answer.)

You are adding an additional LAP to your current wireless network, which uses LWAPP. The
LAP is configured with a static IP address.

Which of the following steps is the first step when the LAP attempts to register with a WLC?
(Select the best answer.

You are configuring a fiber connection between two Cisco Catalyst 3750 switches on which
UDLD is disabled. You connect both the transmit and receive connectors on one end of the
cable to port 1/0/9 on Switch

Which of the following is not information provided from an IP phone to a Catalyst switch
using CDP? (Select the best answer.)

Which of the following are functions that are often provided by an ITSP but are not typically
provided by the PSTN? (Select 2 choices.)

Which of the following should you enable to prevent a switch from forwarding packets with
source addresses that are outside an administratively defined group? (Select the best
answer.)

On an Aironet card, LED 0 and LED 1 are blinking alternately. What does this indicate?