You have just purchased a new Cisco 3560 switch running the enhanced IOS and need
configure it to be installed in a high availability network. On a 3560 EMI switch, which three
types of interfaces can be used to configure HSRP? (Select three)

You need to configure two Company routers for high availability. Which protocol enables a
group of routers to form a single virtual router and use the real IP address of a router as the
gateway address?

You want to implement a high availability network using two Cisco routers. You also want to
ensure that the stat of the WAN interfaces can be tracked in doing so. Which router
redundancy protocol cannot be configured for interface tracking?

HSRP has been configured between two Company devices. Which of the following describe
reasons for deploying HSRP? (Select all that apply)

Company uses GLBP to provide for router redundancy in the network. Which describes the
default load balancing scheme used by the Gateway Load Balancing Protocol (GLBP)?

Routers R1 and R2 use HSRP so that one router will back up the other should there be a
failure. Which two statements are true about the Hot Standby Router Protocol (HSRP)?
(Select two)

You want to implement router redundancy in the Company network using the best method
available. Which protocol specified by RFC 2281 provides network redundancy for IP
networks, ensuring that user traffic immediately and transparently recovers from first-hop
failures in network edge devices or access circuits?

You need to decide on the best router redundancy protocol to use in the Company network.
Which two statements are true about HSRP, VRRP, and GLBP? (Select two)

You need to implement a high availability design in the Company routed network. Which
protocol allows for the automatic selection and simultaneous use of multiple available
gateways as well as automatic failover between those gateways?

R1 and R2 exchange HSRP between each other in the Company network. In which three
HSRP states do routers send hello messages? (Select three)