Refer to the exhibit. The user who is connected to interface FastEthernet 0/1 is on VLAN 10
and cannot access network resources. On the basis of the information in the exhibit, which
command sequence would correct the problem?

You need make configuration changes to an existing layer 3 switch in the Company network.
On a multilayer Catalyst switch, which interface command is used to convert a Layer 3
interface to a Layer 2 interface?

Refer to the exhibit. The switchport output in Figure 1 displays the default settings of
interface
FastEthernet 0/13 on switch SW1. Figure 2 displays the desired interface settings. Which
command sequence would configure interface FastEthernet 0/13 as displayed in Figure 2?

What command could you enter to display the trunking status of a module/port in the switch?
(Type in the answer below):

The Company administrator has issue the “show vlan id 5” command. What will this
command display? (Select two)

You’re a network administer and you issue the command (show port 3/1) on an Ethernet
port. To your surprise you notice a non-zero entry in the ‘Giants’ column. What could be the
cause of this?

Refer to the show interface Gi0/1 switchport command output shown in the exhibit. Which
two statements are true about this interface? (Choose two.)

Refer to the exhibit. Switch P1S1 is not applying VLAN updates from switch P2S1. What are
three reasons why this is not occurring? (Choose three.)

Refer to the exhibit. Based upon the output of show vlan on switch CAT2, what can we
conclude about interfaces Fa0/13 and Fa0/14?

Refer to the exhibit. On the basis of the output generated by the show commands, which two
statements are true? (Choose two.)