Which of the following specifications is a companion to the IEEE 802.1w Rapid Spanning
Tree Protocol (RSTP) algorithm, and warrants the use multiple spanning-trees?

Which three items are configured in MST configuration submode? (Select three)

Which of the following specification will allow you to: associate VLAN groups to STP
instances so you can provide multiple forwarding paths for data traffic and enable load
balancing?

By default, all VLANs will belong to which MST instance when using Multiple STP?

Which MST configuration statement is correct?

While logged into a Company switch you issue the following command:
CompanySwitch(config-mst)# instance 10 vlan 11-12
What does this command accomplish?

Refer to the show spanning-tree mst configuration output shown in the exhibit. What should
be changed in the configuration of the switch SW_2 in order for it to participate in the same
MST region?

The network administrator maps VLAN 10 through 20 to MST instance 2. How will this
information be propagated to all appropriate switches?

Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both
have had the command spanning-tree mode rapid-pvst issued on them. What will be the
result?

LAB
Refer to the Exhibit.

The information of the question
You will configure FastEthernet ports 0/12 through 0/24 for users who belong to VLAN 20.
Also, all VLAN and VTP configurations are to be completed in global configuration mode as
VLAN database mode is being deprecated by Cisco. You are required to accomplish the
following tasks:
1. Ensure the switch does not participate in VTP but forwards VTP advertisements received
on trunk ports.
2. Ensure all non-trunking interfaces (Fa0/1 to Fa0/24) transition immediately to the
forwarding state of Spanning-Tree.
3. Ensure all FastEthernet interfaces are in a permanent non-trunking mode.
4. Place FastEthernet interfaces 0/12 through 0/24 in VLAN 20