Refer to the exhibit. On the basis of the output generated by the show commands, which two
statements are true? (Choose two.)

The core Company switches are configured to use 802.1Q trunks. Which three statements
are correct with regard to the IEEE 802.1Q standard? (Select three)

Switch R1 has been configured with DTP using the desirable option. Which statement
describes Dynamic Trunking Protocol (DTP) desirable mode?

You need to configure a new Company switch for trunking. Which switch command enables
a trunking protocol that appends a four byte CRC to the packet?

While using a packet analyzer, you notice four additional bytes being added to the packets in
the Company network. Which protocol inserts a four byte tag into the Ethernet frame and
recalculates CRC value?

You need to configure a new Company switch to support DTP. Which DTP switchport mode
parameter sets the switch port to actively send and respond to DTP negotiation frames?

A new Company switch was just configured using the “switchport trunk native vlan 7”
command. What does this interface command accomplish?

You need to connect two Company core switches via an ISL trunk. Which statement is true
regarding the configuration of ISL trunks?

Refer to the exhibit. VLAN 1 and VLAN 2 are configured on the trunked links between Switch
A and Switch B. Port Fa 0/2 on Switch B is currently in a blocking state for both VLANs.
What should be done to load balance VLAN traffic between Switch A and Switch B?

Which of the following technologies would an Internet Service Provider use to support
overlapping customer VLAN ID’s over transparent LAN services?