The wireless survey report shows APs staggered throughout a facility, with several of them placed
right on the exterior walls. Other APs are located right at building corners and major turns in the
structure layout. Assuming all survey locations are optimized with a minimum of ‐67 RSSI at cell
edges with 20% overlapping cells, for what purpose can this survey model be used?

A customer wants to deploy wireless services inside a 500‐seat auditorium. Given the volume of
potential users in this condensed area, what is the best option for AP deployment?

A wireless engineer is gathering equipment to perform a point‐to‐point bridge survey. What three
pieces of equipment should be used? (Choose three.)

What three best practices should be performed for a Data‐Only Survey? (Choose three.)

What are the best practice minimum and recommended signal level values for a Location Services
Survey?

What is a typical attenuation value for a cinder block wall?

Which two details are specified in the Executive Summary section of the Site Survey Report? (Choose
two.)

Before installing new wireless hardware, an engineer collects information from the facility using
Cisco Spectrum Expert. What three devices would be detected during this survey? (Choose three.)

Refer to the exhibit. Clients are being disconnected from the WLAN. Which source of interference
can cause a Denial of Service?

An engineer is conducting a passive survey. On what two items will data be collected? (Choose two.)