Which two statements describe the process identifier that is used in the command to configure
OSPF on a router? (Choose two.)
Router(config)# router ospf 1

Which commands are required to properly configure a router to run OSPF and to add network
192.168.16.0/24 to OSPF area 0? (Choose two.)
maximum Maximum number of parallel routes that OSPF can install in a routing
table. The range is from 1 to 16 routes.

What is the default maximum number of equal-cost paths that can be placed into the routing
table of a Cisco OSPF router?

A network administrator is trying to add a new router into an established OSPF network. The
networks attached to the new router do not appear in the routing tables of the other OSPF
routers. Given the information in the partial configuration shown below, what configuration
error is causing this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The
routers cannot establish an adjacency relationship on their common Ethernet link.

The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.
Based on the information in the graphic, what is the cause of this problem?

Refer to the exhibit.

Assume that all router interfaces are operational and correctly configured. In addition, assume
that OSPF has been correctly configured on router R2. How will the default route configured on
R1 affect the operation of R2?