What type or types of application traffic should be considered?
Performance requirements for aggregation-to-aggregation traffic flows through the core layer are being assessed. What type or types of application traffic should be considered?
Which BGP attribute will not be advertised in routing updates to its neighboring routers?
Which BGP attribute will not be advertised in routing updates to its neighboring routers?
Given the exhibited configuration commands, which statement is true?
A network administrator is troubleshooting a redistribution of RIP routes into OSPF. Given the exhibited configuration commands, which statement is true?
Which statement describes a feature of this spanning-tree topology?
Refer to the exhibit.
Which statement describes a feature of this spanning-tree topology?
Which VTP information does a Catalyst switch advertise on its trunk ports when using VTP? (Choose two
Which VTP information does a Catalyst switch advertise on its trunk ports when using VTP? (Choose two.)
What should be done to propagate this route?
A company has a BGP network and a BGP route of 196.27.125.0/24 that should be propagated to all of the devices. The route is not now in any of the routing tables. The administrator determines that an access list is the cause of the problem. The administrator changes the access list to allow this route, but the route still does not appear in any of the routing tables. What should be done to propagate this route?
Which statement represents the best advice?
Refer to the exhibit. A data center network is configured as follows:
ACE modules
active/active failover pair
core-to-aggregation traffic load balanced
load balancing via Layer 3 source-destination IP address hashing
Which statement represents the best advice?
If the STP configuration is correct, what will be true about Switch 15?
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct, what will be true about Switch 15?
Which router will assume the active role when Link A becomes operational again?
Refer to the exhibit. HSRP has been configured and Link A is the primary route to router R4. When Link A fails, router R2 (Link B) becomes the active router. Which router will assume the active role when Link A becomes operational again?
Which Cisco Catalyst 6500 Series line card is recommended for aggregation-to-core uplinks?
Which Cisco Catalyst 6500 Series line card is recommended for aggregation-to-core uplinks?