A router is set to boot from flash, but cannot find boot commands in the configuration. Also, valid files do not exist in the default flash device. The router will:

Click the Exhibit button to view the topology.

As shown in the diagram, a building in your campus network has two layer 3 switches in the distribution layer and four layer 2 switches in the wiring closets. The layer 3 switches are labeled R1 and R2. The layer 2 switches are labeled A1, A2, A3, and A4. Access switch A1 is configured as the root switch of VLAN 1. Each access switch has a single subnet and the uplinks are configured as access ports, not VLAN trunks. If the uplink labeled X is cut, how long does spanning tree protocol interrupt connectivity before it converges?

A network operator wants to have a continuous view of network alarms as they occur. What CTM component will provide this functionality?

Click the Exhibit button.

The exhibit shows OC-12 POS connections across various transport media. Which are correct timing configurations for 7600 interfaces (A) and (B)? (Note: connection between routers B and C is set to internal timing.)

How do FCIP and ISCSi differ?

Click the Exhibit button to view the topology.
Host 1 and Host 2 are on Ethernet LANs in different buildings. A serial line is installed between two Cisco routers using Cisco HDLC serial line encapsulation. Routers A and B are configured to route IP traffic. Host 1 sends a packet to Host 2. What is the destination MAC address of the packet on Host’s 1 Ethernet?

When an ML-series RPR ring is provisioned over a SONET BLSR (or SDH MS-SPR) ring, the ML architecture can no longer utilize the full available bandwidth on the SONET/SDH ring due to the constraints of BLSR. Which features are being introduced to allow use of discontiguous timeslots and BLSR protect channels when provisioning ML-series RPR rings, in order to alleviate this limitation?