What happens?
Routers E and F are configured for HSRP (Hot Standby Routing Protocol). E has a priority of 100, while F has a priority of 50. At one point, when E is the active router, it fails, and F takes over as the active router. A few minutes later, E returns to service. What happens?
Find the problem in the following configuration:
Find the problem in the following configuration:vpdn enablevpdn-group 1request-dialinprotocol pppoevirtual-template 2!interface atm 2/0.1 point-to-pointpvc 0/101encapsulation aal5snapprotocol pppoe!interface atm 2/0.2 point-to-pointpvc 0/102encapsulation aal5snapprotocol pppoe!interface atm 2/0.3 point-to-pointpvc 0/103encapsulation aal5snapprotocol pppoe!interface virtual-template 2ip unnumbered Fastethernet 4/0!interface FastEthernet 4/0ip address 172.22.32.1 255.255.255.0
What VCI value is reserved for PNNI ATM routing?
What VCI value is reserved for PNNI ATM routing?
What will the encapsulation type for the PVCs be?
The following configuration is entered on an ATM interface:interface atm 0/0/0encapsulation aal5mux ppp virtual-template 1interface atm 0/0/0.10 multipointpvc 0/100exitpvc
0/101encapsulation aal5snapWhat will the encapsulation type for the PVCs be?
The ATM Transmission Convergence Sublayer is NOT responsible for:
The ATM Transmission Convergence Sublayer is NOT responsible for:
One of the main security issues with the WEP protocol stems from?
One of the main security issues with the WEP protocol stems from?
What is the function of NSP Cross-Connections in the usage of a 6400 in a production network. (multiple answer
What is the function of NSP Cross-Connections in the usage of a 6400 in a production network. (multiple answer)
What ATM Adaptation Layer is used when an ATM cell carries IP packets and PPP frames?
ATM carries IP and PPP information within ATM cells. What ATM Adaptation Layer is used when an ATM cell carries IP packets and PPP frames?
What does the command “ubr 384” accomplish?
A PVC has been configured on the 6400 NRP as follows:pvc
1/100encapsulation aal5mux ppp virtual-template 1ubr 384What does the command “ubr 384” accomplish?
what is the subscriber’s trouble symptom?
The following configuration is from a Cisco DSLAM:interface ATM1/1no ip addressdsl profile basicno atm ilmi-keepaliveatm pvc 2 32 interface ATM0/1 1 32This configuration is from a Cisco 2600 router with an ADSL WIC installed:interface ATM0/0.1 point-to-pointip address 192.168.1.2 255.255.255.0pvc 1/32protocol ip 192.168.1.1 broadcastencapsulation aal5snapThe CPE is connected to DSLAM DSL port 1/1 via a DSL line. The subscriber’s DSL service is not working correctly. Based on the information shown in these two “show run” output messages, what is the subscriber’s trouble symptom?