A router is set to boot from flash, but cannot find boot commands in the configuration. Also, valid files do not exist in the default flash device. The router will:

What statement is correct regarding Virtual LANs (VLANs)?

What establishes routing table precedence in a routing table?

OSPF is defined on a Frame Relay interface providing point-to-multipoint connections. The remote neighbors can reach this central site, but are complaining of routing failures between each of the remote sites. The central router has all the routes for each remote site. Based on this information, what can be diagnosed as the biggest potential problem?

You work as a network engineer at domain .com. Study the exhibit carefully. In the shown scenario, the inside VIP address is translated by the firewall into the external ip address 172.16.1.10. The CSS interface E1 IP address is translated into 172.16.1.2. If you want to check the status of the CSS VIP from the GSS using a keepalive of type KAL-AP, what type of configuration would be needed? Exhibit:

You work as a network administrator at domain .com. Study the exhibit carefully. Look at the router configuration above. If this router has a configuration-register setting of 0x102, select the proper boot sequence:
Exhibit:

Study the Topology Exhibit.
Router domain .com A has a 512K-access port into the frame relay cloud. Router domain .com B has 128K-access port into the frame relay cloud. The two routers are connected with symmetrical PVCs that are configured for 64K committed information rate (CIR). What Frame Relay Traffic Shaping map-class sub-command should be entered on Router domain .com A to prevent workstation domain .com 1 from overrunning the access port on Router domain .com B?
Exhibit:

You work as a network engineer at domain .com. Study the topology exhibit carefully. Assuming default spanning tree configurations are running between two switches with redundant trunks:
Exhibit: