Which PIN architecture is applicable in those environments?
You work as a network administrator in your company. Communication inside the company is ensured by network environments, such as GET VPN, Dynamic Multipoint VPN and Ethernet. Which PIN architecture is applicable in those environments?
Which two of these are possible causes?
Domain .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuring both routers, issuing the show interface s0/0 command on the Cisco router shows the interface to be in the up/down state. Which two of these are possible causes? (Choose two.)
which one is able to supply a core infrastructure so that customers can capitalize quickly with the change of
Refer to the following architectures, which one is able to supply a core infrastructure so that customers can capitalize quickly with the change of business requirements?
Which two of these accurately describe this router’s supervisor redundancy status?
Refer to the exhibit. Which two of these accurately describe this router’s supervisor redundancy status? (Choose two.)
Which of these commands can you use to show if an operational Catalyst switch port is set for autonegotiation
Which of these commands can you use to show if an operational Catalyst switch port is set for autonegotiation of speed and duplex when running Cisco IOS software?
What is the HSRP state and priority of this interface after HSRP reaches its steady state?
Refer to the exhibit. What is the HSRP state and priority of this interface after HSRP reaches its steady state?
Which TWO of the following wii be available and shared between the routers configured with HSRP?
HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network. Which TWO of the following wii be available and shared between the routers configured with HSRP? (Choose two.)
which configuration command is used to apply a VACL named “test” to filter the traffic within VLAN
On a Cisco Catalyst switch, which configuration command is used to apply a VACL named “test” to filter the traffic within VLAN100?
which two descriptions make sense?
Hot Standby Router Protocol (HSRP) is able to provide network redundancy for IP networks. Concerning HSRP load sharing, which two descriptions make sense?
Which MAC address will your default gateway use?
You have just configured HSRP group 10 in vour network, Which MAC address will your default gateway use?