How does the Cisco IOS IPS feature set monitor the network for malicious activity?
How does the Cisco IOS IPS feature set monitor the network for malicious activity?
Which error was made at initial configuration?
After performing the initial switch configuration by running the setup utility, an administrator notices that ports configured to connect to other Cisco MDS 9000 switches invariably come up as E_Ports rather than TE_Ports. Which error was made at initial configuration?
How are Cisco MDS 9000 distributed device aliases synchronized between all switches in the fabric?
How are Cisco MDS 9000 distributed device aliases synchronized between all switches in the fabric?
how many bits in the IPv4 address are used to identify the network?
On a Class C IP network, how many bits in the IPv4 address are used to identify the network?
replication solution would you recommend?
A customer has a need to synchronously replicate data from the primary data center to a standby data center that is 30 kilometers away. The customer owns the fiber between the two data centers and uses the link for Gigabit Ethernet connectivity today. The Gigabit Ethernet connection is heavily utilized and generally remains at 90-percent utilization. The customer expects that the replication traffic will require approximately 30 MBps, and is looking for a low-cost solution. Which
21
replication solution would you recommend?
What are four valid protocols for copying software to the MDS 9000 family switches?
What are four valid protocols for copying software to the MDS 9000 family switches? (Choose four.)
what will the ISL oversubscription ratio be?
Your customer has 40 servers attached to the edge switch in a corE.edge design. Each server’s average throughput is between 22 and 35 MB. How many 4 GB ISLs should be provisioned between the edge and the core, and what will the ISL oversubscription ratio be?
which three settings should be configured during the initial setup of a Cisco 9000 Series switch using SAN-OS
In order to allow access to a switch using Telnet, which three settings should be configured during the initial setup of a Cisco 9000 Series switch using SAN-OS Release 2.0? (Choose three.)
What are three key benefits of implementing a SAN using iSCSI?
What are three key benefits of implementing a SAN using iSCSI? (Choose three.)
How can you specify primary and secondary paths for each FCIP tunnel?
You are implementing an FCIP solution for SAN extension between two data centers using the Cisco MDS 9000 Series platform. For redundancy, there are two Metro Ethernet paths between the data centers. How can you specify primary and secondary paths for each FCIP tunnel?