What should the service provider’s equipment support to maximize the FCIP throughput with minimum overhe
A customer is about to deploy a primary and secondary data center using the service provider’s network to connect the data center’s IP and Fibre Channel networks to connect the SAN island with FCIP tunnels. What should the service provider’s equipment support to maximize the FCIP throughput with minimum overhead? Select the best response.
Which error was made at initial configuration?
After performing the initial switch configuration by running the setup utility, an administrator notices
that ports configured to connect to other Cisco MDS 9000 switches invariably come up as E_Ports
rather than TE_Ports. Which error was made at initial configuration?
What command would you execute to change the domain ID on a Cisco MDS switch?
What command would you execute to change the domain ID on a Cisco MDS switch? Select the best response.
how many bits in the IPv4 address are used to identify the network?
On a Class C IP network, how many bits in the IPv4 address are used to identify the network?
What MDS 9000 feature provides more efficient SAN utilization by creating hardware-based isolated environments
What MDS 9000 feature provides more efficient SAN utilization by creating hardware-based isolated environments within a single physical SAN infrastructure?
What are four valid protocols for copying software to the MDS 9000 family switches?
What are four valid protocols for copying software to the MDS 9000 family switches? (Choose
four.)
What should you do to allow iSCSI hosts on multiple subnets to connect to a single GigE interface on an IPS mo
What should you do to allow iSCSI hosts on multiple subnets to connect to a single GigE interface on an IPS module?
the initial setup of a Cisco 9000 Series switch using SAN-OS Release 2.0?
In order to allow access to a switch using Telnet, which three settings should be configured during
the initial setup of a Cisco 9000 Series switch using SAN-OS Release 2.0? (Choose three.)
How does RolE.Based Access Control (RBAC) enhance manageability in an environment with VSANs?
How does RolE.Based Access Control (RBAC) enhance manageability in an environment with VSANs?
How can you specify primary and secondary paths for each FCIP tunnel?
You are implementing an FCIP solution for SAN extension between two data centers using the
Cisco MDS 9000 Series platform. For redundancy, there are two Metro Ethernet paths between
the data centers. How can you specify primary and secondary paths for each FCIP tunnel?