Which feature can only be found on the Catalyst 2960?
A customer is considering purchasing either a Cisco Catalyst 2960 or Cisco Catalyst Express 500. Which feature can only be found on the Catalyst 2960?
interconnect the MDS (SAN) and the Nexus 5000 (LAN)?
Refer to the exhibit. Which two options do you need to deploy for the topology depicted to
interconnect the MDS (SAN) and the Nexus 5000 (LAN)? (Choose two.)
McData multivendor using interoperability mode 1?
Refer to the exhibit.
Which action should you take to connect the Cisco MDS Switch to an existing Brocade and
McData multivendor using interoperability mode 1?
Exhibit:
Which two of these features are only supported by an ASA Security Appliance?
The PIX Security Appliance feature set is a subset of the ASA Security Appliance feature set. Which two of these features are only supported by an ASA Security Appliance? (Choose two.)
two paths, while preserving redundancy?
Refer to the exhibit.
The customer network has blue and red VSANs redundantly connected. Path A having a 4-ISL
port channel and Path B having a 2-ISL port channel. Changes to the physical topology are not
allowed for the next six months. All the traffic now flows over Path A with congestion occurring on
both VSANs at peak times. The blue VSAN is, on the average, generating four times the amount
of data than that of the red VSAN. How can the blue and red VSAN traffic be separated over the
two paths, while preserving redundancy?
Exhibit:
are used by servers?
You have deployed a Fibre Channel network with iSCSI-attached servers and clients in multiple IP
networks. In you Fibre Channel network, you have deployed a Cisco MDS 9222i switch as an
iSCSI gateway. Which option prevents clients from attaching to different iSCSI virtual targets that
are used by servers?
which type of companies?
The Cisco Lifecycle Services approach is primarily applicable to which type of companies?
What alarm will be sent for this RMON event?
Refer to the exhibit.
What alarm will be sent for this RMON event?
Exhibit:
which iSCSI-enabled servers should be connected to the Fibre Channel targets?
Which command in used to configure VLAN 100 on the Gigabit Ethernet 2/1 interface through
which iSCSI-enabled servers should be connected to the Fibre Channel targets?
What are two Cisco IOS commands that would verify connectivity between routers R1 and R2?
Refer to the exhibit. What are two Cisco IOS commands that would verify connectivity between routers R1 and R2? (Choose two.)
