What are two ways to test the LAN connectivity on the Cisco CE520?
What are two ways to test the LAN connectivity on the Cisco CE520? (Choose two.)
What are two differences between medium and large campus network designs?
What are two differences between medium and large campus network designs? (Choose two)
which method is a rogue contained?
In an infrastructure based on a wireless advanced feature set using lightweight access points, by which method is a rogue contained?
component in the operate phase?
Which benefit can be obtained by using the change management service
component in the operate phase?
How do the Cisco ISR G2 platforms enable the next phase of branch-office evolution?
How do the Cisco ISR G2 platforms enable the next phase of branch-office evolution?
which step should the customer take to fix the situation?
A North American customer is using 2.4-GHz radios in a point-to-point configuration. The radio power level is 17 dBm and is transmitting at 11 Mbps. The customer is using 21.5-dBi dish antennas and 50 feet of cabling, with a loss of 8.4 dB per 100 feet. The customer increased the distance between the transmitter stations and began experiencing link problems.
Without using a professional installer, which step should the customer take to fix the situation?
Which interface on the Cisco UC520 is assigned an IP address either statically or through DHCP?
Which interface on the Cisco UC520 is assigned an IP address either statically or through DHCP?
Which three elements can you review when examining the traffic across a network?
Which three elements can you review when examining the traffic across a network? (Choose three)
What are two possible causes?
OSPF routes are being redistributed into EIGRP but they are not showing up in the routing table. What are two possible causes? (Choose two.)
What does PVST+ do to correct this?
Refer to the exhibit. Switches A and C are running PVST+ STP, and Switch B is running 802.1Q STP. If the BPDU of the root in VLAN 1 is better than the BPDU of the root in VLAN 2, then there is no blocking port in the VLAN 2 topology. The BPDU of VLAN 2 never makes a “full circle” around the topology; it is replaced by the VLAN 1 BPDU on the B-C link, because B runs only one STP merged with VLAN 1 STP of PVST+. Thus, there is a forwarding loop.
What does PVST+ do to correct this?