How will this reconfiguration affect the voice network bandwidth and delay characteristics?
You are the network engineer at domain.com.TestKing has been using the following dial peer codec command:
Codec g729r8
You reconfigure the dial peers with the following command:
Codec g729ar8 bytes 10
How will this reconfiguration affect the voice network bandwidth and delay characteristics? (Choose two.)
What are two techniques that exist for this?
For very low-speed links (those with a link speed of less than 768 K), it is necessary to use techniques that provide link fragmentation and interleaving of packets. This prevents voice traffic from being delayed behind large data frames and hence bounds jitter.
What are two techniques that exist for this?
what is the length of the packet header if cRTP is deployed without redundancy checks?
In a VoIP environment when speech samples are framed every 20 ms, a payload of 20 bytes is generated. Assuming a total packet length of 60 bytes, what is the length of the packet header if cRTP is deployed without redundancy checks?
which term from the list below?
With Cisco CallManager Release 3.0, the term “route point” is replaced with which term from the list below?
Which command parameter specifies that the router should not attempt to initiate a trunk connection but should
Which command parameter specifies that the router should not attempt to initiate a trunk connection but should wait for an incoming call before establishing the trunk?
Which command would you use?
You are the network engineer at domain.com. TestKing has its headquarters inNew Yorkand a branch office inDelaware.In the branch office, oneVoIPdial-peer has been configured to point to headquarters over a low speed serial link. You want to limit the maximum number of concurrent calls to 3.
Which command would you use?
What can be used to simplify this task?
A telemarketing firm needs to use number translation for incoming and outgoing calls. They have defined two translation profiles, one for incoming and one for outgoing calls. What can be used to simplify this task?
Which dial peer should you configure to point to the senior agent?
You are the network engineer at domain.com. You have configured dial peers in a hunt group for a Support team that answers when the number 5952215 is dialled. The Support team consists of one senior agent and three junior agents. You want the senior agent to receive the incoming call first.
Which dial peer should you configure to point to the senior agent?
What is the correct diagnosis for the problem?
Refer to the exhibit. Users are not able to complete a call from 678-555-1212 to 770-555-1111. What is the correct diagnosis for the problem?
What could happen if theplayoutdelay buffer size is configured too large?
What could happen if theplayoutdelay buffer size is configured too large?