Which device listed below has an intelligent power management system
Which device listed below has an intelligent power management system that grants or denies power to various system components based on power availability in the system for use with IP telephony?
Select two from the list below.
When analyzing the WAN for IP Telephone deployment, you need to collect information from the WAN and LAN devices. You need to determine current Bandwidth usage before rolling out a solution. From the analysis you are performing, there are categories you can collect information from.
Select two from the list below.
Choose the correct FXO port configuration commands for New York
Refer to the exhibit for IP addresses and telephone numbers. You are working with a customer opening a small sales office in Atlanta. You want the user in Atlanta to be able to dial into the PBX in New York over the IP WAN. The New York PBX uses ground start, a two-wire operation, and DTMF dialing. Choose the correct FXO port configuration commands for New York.
When these gateways initialize, a list of CiscoCallManager’s, referred to
When they are booted, the Cisco Access Digital Trunk Gateway DT-24+, the Cisco Access Digital Trunk Gateway DE-30+, and the Catalyst 6000 digital gateway are provisioned with Cisco CallManager location information. When these gateways initialize, a list of CiscoCallManager’s, referred to as a ______________ is downloaded to the gateways.
Calls between IP and PBX users can use all of the features provided by each system
Calls between IP and PBX users can use all of the features provided by each system, and that subset is defined by the level of complexity of the voice interface between the IP network and the PBX.
Currently, unlike traditional phone service, IP telephone service is relatively unregulated by government
Currently, unlike traditional phone service, IP telephone service is relatively unregulated by government.
Which two configuration commands are used to apply an inspect policy map for traffic traversing from the E0 or
What should you check to troubleshoot this issue?
When you implement Cisco IOS WebVPN on a Cisco router using a self-signed certificate, you notice that the router is not generating a self-signed certificate. What should you check to troubleshoot this issue?