Which of the following support XMPP? (Select 3 choices.)

Which of the following UCM device settings fields identifies the specific hardware device that is being
configured? (Select the best answer.)

Which of the following devices are not found in the endpoints layer in the Cisco Unified Communications
Architecture? (Select 2 choices.)

You are integrating an existing Cisco Unity Connection user with an existing LDAP user. However, the user’s
Unity Connection Alias field does not match the LDAP user ID.
Which of the following should you do prior to using the BAT to import the LDAP data? (Select the best answer.)

You want to allow a traditional telephone handset to operate as an IP phone on a Cisco network.
Which of the following Cisco devices would accomplish this task? (Select the best answer.)

Refer to the diagram.

The IP phone at extension 1002 uses SCCP to communicate with the CME router. The IP phone at extension
1001 uses SIP to communicate with the CME router.
Which of the following protocols will the IP phones use to carry voice data during a call between extension 1001
and extension 1002? (Select the best answer.)

Which of the following commands are not required to configure basic telephony service on a CME router?
(Select 2 choices.)

Which of the following Cisco Unity Connection Port Monitor fields are most likely to display a value of Idle?
(Select 3 choices.)

You issue the following commands on a CME router:
CME1#configure terminal
CME1(config)#ephone 6
CME1(config-ephone)#username john password b0s0n
CME1(config-ephone)#end
Which of the following best describes the type of CME user you just configured? (Select the best answer.

Which of the following will occur when you press the **#** keypad sequence at the Settings menu of a Cisco IP
phone? (Select the best answer.)