Which routes would be redistributed into OSPF area 1?
Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1?
Select the best response.
which command should be added, or edited, on router B1 under router ospf 10?
Refer to the exhibit. The network administrator is trying to configure mutual redistribution between EIGRP and OSPF. Autosummarization in EIGRP 100 AS is disabled. After adding OSPF configuration to router B1, the network administrator checked the routing table of router B2, but none of the EIGRP routes appeared there.
To redistribute the EIGRP AS 100 routes into OSPF, which command should be added, or edited, on router B1 under router ospf 10?
Select the best response.
Which three commands should be used on router B1 to redistribute the EIGRP AS 10 routes into RIP?
Refer to the exhibit. Which three commands should be used on router B1 to redistribute the EIGRP AS 10 routes into RIP? (Choose three.)
Select 3 response(s).
what is one reason why no routes from the OSPF neighbor 192.168.0.5 are installed in the IP routing table?
Refer to the exhibit. Based on the command output, what is one reason why no routes from the OSPF neighbor 192.168.0.5 are installed in the IP routing table?
Select the best response.
Which statement about these configurations is true?
Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable.
Which statement about these configurations is true?
Select the best response.
Which ACL statement completes the configuration correctly?
Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default-network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly?
Select the best response.
Which would be the first logical step to take?
Refer to the exhibit. Based upon the configuration, you need to understand why the policy routing match counts are not increasing.
Which would be the first logical step to take?
Select the best response.
How would you confirm on R1 that load balancing is actually occurring on the default-network (0.0.0.0)?
Refer to the exhibit. How would you confirm on R1 that load balancing is actually occurring on the default-network (0.0.0.0)?
Select the best response.
Which commands would create this configuration?
Refer to the exhibit. R1 accesses the Internet using E0/0. You have been asked to configure R1 so that a default route is generated to its downstream devices (191.0.0.1 and 192.0.0.1).
Which commands would create this configuration?
Select the best response.
Which two EIGRP subcommands would you use to accomplish this goal?
Refer to the exhibit. You want to use all the routes in the EIGRP topology for IP load balancing.
Which two EIGRP subcommands would you use to accomplish this goal? (Choose two.) Select 2 response(s).