Which command would verify if PBR reacts to packets sourced from 172.16.0.0/16?
Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0/16?
Select the best response.
Which two Cisco IOS commands on R2 would verify its OSPF neighbor relationships?
Refer to the exhibit. Which two Cisco IOS commands on R2 would verify its OSPF neighbor relationships? (Choose two.)
Select 2 response(s).
Which statement about this neighbor of R1 is true?
Refer to the exhibit. Which statement about this neighbor of R1 is true?
Select the best response.
Which statement about the plan is true?
Refer to the exhibit. ROUTE.com is planning to implement load balancing for traffic between hosts on the 172.16.10.0/24 and 172.16.20./24 networks. You have been asked to review the implementation plan for this project.
Which statement about the plan is true?
Select the best response.
What can be done so that data will be routed along the most optimal path in the network?
Refer to the exhibit. Router B and router C are performing mutual redistribution between OSPF and EIGRP, and their default metrics are configured the same. Router D has equal cost paths to networks where both paths are not really equal cost. For example, network 172.16.54.0 shows equal cost through both router B and router C, though in reality the cost is greater using router C. Other routers, though not shown, are connected to the 172.16.54.0 and 172.16.55.0 networks, and the same issues exist to those routers and the networks connected to them.
What can be done so that data will be routed along the most optimal path in the network?
Select the best response.
What on router C may be the cause of the problem?
Refer to the exhibit. EIGRP has been configured on router D. Router C is performing mutual redistribution between EIGRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause of the problem?
Select the best response.
Which change to router B would accomplish these goals?
Refer to the exhibit. Router B is performing bidirectional redistribution between EIGRP and OSPF. The network 10.100.1.0/24 should not be reachable from the 10.100.9.0/24 network. However, it needs to be reachable from any network within the EIGRP domain. All other networks should be seen in both domains.
Which change to router B would accomplish these goals?
Select the best response.
Which of the following additions to the configuration is most likely to solve the problem?
Refer to the exhibit. AS 65500 is not advertising the prefix 192.168.12.0/22 to its provider.
AS 65500 is running OSPF as its IGP.
Which of the following additions to the configuration is most likely to solve the problem?
Select the best response.
What can be done to fix the problem?
RouterA#debug ip ospf events
OSPF events debugging is on
RouterA#
04:43:16: OSPF: Rcv pkt from 10.3.0.2, Ethernet0/1, area 0.0.0.1 mismatch area 0.0.0.2 in the header
04:43:19: OSPF: Rcv hello from 10.100.100.3 area 0 from Ethernet0/0 10.1.0.1
04:43:19: OSPF: End of hello processing
Refer to the exhibits. What can be done to fix the problem?
Select the best response.
Which statement is correct about router C?
Refer to the exhibit. Router C was configured so that it could form an adjacency with three OSPF neighbors, one connected to each of its three physical interfaces.
Which statement is correct about router C?
Select the best response.