Refer to the exhibit.

Consider the following scenario:
A packet sourced from host 10.2.2.2, port 65001, is going to host 10.1.1.2 on the Telnet port. Assuming that this ACL is properly applied on the switch, if this packet is fragmented, which of the following conditions will result, based upon the access list shown in the exhibit?

Refer to the exhibit. Which of these is true based upon the output shown in the command?

Refer to the exhibit.

Consider the following scenario:
Packet A is a TCP packet from host 10.2.2.2., port 65000, going to host 10.1.1.1 on the SMTP port. Assuming that this ACL is properly applied on the switch, if this packet is fragmented, which two of the following statements are true, based on the configuration shown in the exhibit? (Choose two.)

Refer to the exhibit. From the configuration shown, what can you determine about the private VLAN configuration? *

hostname Switch1
interface Vlan10
ip address 172.16.10.32 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 700
standby 1 preempt

hostname Switch2
interface Vlan10
ip address 172.16.10.33 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 750
standby 1 priority 110
standby 1 preempt

hostname Switch3
interface Vlan10
ip address 172.16.10.34 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 750
standby 1 priority 150
standby 1 preempt

Refer to the exhibit. Three switches are configured for HSRP. Switch1 remains in the HSRP listen state. What is the most likely cause of this status?

Refer to the exhibit. What happens when the switch SW2 is connected to the rest of the network in the VTP domain Lab_Network?

Refer to the exhibit. Which two statements are true? (Choose two.)

Refer to the exhibit. From the configuration shown, what can be determined?

Cat6500(config)# router ospf 1
Cat6500(config-router)# network 0.0.0.0 255.255.255.255 area 0
Cat6500(config-router)# nsf
Cat6500(config-router)# end

Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series Switch with redundant supervisor engines.

The default CEF configuration is unchanged. After testing, user traffic is interrupted and NSF is not operational. What is the most likely reason?

Refer to the exhibit. What problem is preventing users on VLAN 100 from pinging addresses on VLAN 200?