which three statements are true?
Refer to the exhibit. An administrator is verifying that a CEF FIB entry exists to destination network 192.168.150.0. Given the output generated by the show ip cef and show adjacency detail commands, which three statements are true? (Choose three.)
what is the cause of this problem?
The network operations center has received a call stating that users in VLAN 107 are unable to access resources through Router 1. From the information contained in the graphic, what is the cause of this problem?
Exhibit
What might explain what happened?
A switch that is to be added to the production network has been preconfigured (trunks, VLANs, VTP, and STP) and was tested in your lab. After installing the switch into the network, the entire network went down. What might explain what happened?
what can you determine regarding EIGRP routing being performed by the switch?
Refer to the exhibit. Based on the output of the show command, what can you determine regarding EIGRP routing being performed by the switch? *
what can you determine?
Refer to the exhibit. Based upon the output shown, what can you determine?
which two statements are correct regarding this Layer 3 security configuration example?
Refer to the exhibit. Based on the configuration shown, which two statements are correct regarding this Layer 3 security configuration example? (Choose two.)
what can you determine regarding Layer 3 routing functionality of the interface?
Refer to the exhibit. From the configuration sample shown of a Cisco Catalyst 3560 Series Switch,what can you determine regarding Layer 3 routing functionality of the interface?
what can be determined?
Refer to the exhibit. You have configured an interface to be an SVI for Layer 3 routing capabilities. Assuming that all VLANs have been correctly configured and based on the configuration example shown, what can be determined?
Which statement best describes first-hop redundancy protocol status, given the command output in the exhibit?
Which statement best describes first-hop redundancy protocol status, given the command output in the exhibit? *
Switch# show ip arp
Protocol AddressAge(min) Hardware Addr Type Interface
Internet 172.16.233.229 0000.0c59.f892 ARPA Vlan10
Internet 172.16.233.218 0000.0c63.1300 ARPA Vlan10
Internet 172.16.233.19 0000.0c07.ac0b ARPA Vlan10
What best describes the Cisco IOS IP SLA command and output in the exhibit?
Switch# show ip sla application
IP SLAs
Version: 2.2.0 Round Trip Time MIB, Infrastructure Engine-II Time of last change in whole IP SLAs: 22:17:39.117 UTC Fri Jun Estimated system max number of entries:15801
Estimated number of configurable operations: 15801 Number of Entries configured: 0
Number of active Entries: 0
Number of pending Entries: 0
Number of inactive Entries: 0
Supported Operation Types
Type of Operation to Perform: 802.1agEcho
Type of Operation to Perform: 802.1agJitter
Type of Operation to Perform: dhcp
Type of Operation to Perform: dns
Type of Operation to Perform: echo
Type of Operation to Perform: ftp
Type of Operation to Perform: http
Type of Operation to Perform: jitter
Type of Operation to Perform: pathEcho
Type of Operation to Perform: pathJitter
Type of Operation to Perform: tcpConnect
Type of Operation to Perform: udpEcho
IP SLAs low memory water mark: 21741224
Refer to the exhibit. What best describes the Cisco IOS IP SLA command and output in the exhibit?