During routine maintenance, G1/0/1 on DSW1 was shutdown. All other interface were up. DSW2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DSW1 was reactivated. DSW1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly?

Interface VLAN 101 exhibit:

Refer to the exhibit. Switch S1 is running mst IEEE 802.1s. Switch S2 contains the default configuration running IEEE 802.1D. Switch S3 has had the command spanning-tree mode rapid-pvst running IEEE 802.1w. What will be the result?

If G1/0/1 on DSW1 is shutdown, what will be the current priority value of the Vlan105’s group on DSW1?

Interface VLAN 105 exhibit:

During routine maintenance, it became necessary to shutdown G1/0/1 on DSW1. All other interface were up. During this time, DSW1 remained the active device for Vlan 102’s HSRP group. You have determined that there is an issue with the decrement value in the track command in Vlan 102’s HSRP group. What need to be done to make the group function properly?

Interface VLAN 102 exhibit:

Refer to the exhibit. On the basis of the output generated by the show commands, which two statements are true? (Choose two)

Refer to the exhibit. Assume that Switch_ A is active for the standby group and the standby device has only the default HSRP configuration. What conclusion is valid?

Which optional feature of an Ethernet switch disables a port on a point-to-point link if the port does not receive traffic while Layer 1 status is up?

Given the diagram and assuming that STP is enabled on all switch devices, which two statements are true? (Choose two.)
Exhibit

What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?

Refer to the exhibit. Which statement is true about the output?