Which will be the most likely cause of this problem?
You work as a network technician at Company.com, study the exhibit provided. You are implementing this QoS configuration to improve the bandwidth guarantees for traffic towards two servers, one with the IP address 5.5.5.5 and the other with the IP address 5.5.5.4. Even after the configuration is applied, performance does not seemto improve. Which will be the most likely cause of this problem?
What will you do at PG-R5 to solve this problem?
Based on the exhibit presented. PG-R2 does not have any 10.100.x.x routes in either its routing table or its BGP table. What will you do at PG-R5 to solve this problem?
what is the maximum number of queries PG-R3
On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?
Based on the network displayed in the exhibit, both PG-R1 and PG-R2 are configured as EIGRP stub routers
Based on the network displayed in the exhibit, both PG-R1 and PG-R2 are configured as EIGRP stub routers. If the link between PG-R1 and PG-R3 is down, will PG-R3 still be able to reach 192.168.1.0/24, and why or why not?
what would be the status of each path to 172.30.1.0/24?
On the basis of the exhibit provided, assuming that EIGRP is the routing protocol, then at R5, what would be the status of each path to 172.30.1.0/24?
why 10.1.4.0/24 is not in PG-R1’s routing table?
Look at the following exhibit carefully, there is no route to 10.1.4.0/24 in the local routing table. According to the output of PG-R1 in the exhibit, can you tell me why 10.1.4.0/24 is not in PG-R1’s routing table?
how to route the traffic arriving at PG-R1 for 10.1.3.1?
Based on the network provided in the exhibit, how to route the traffic arriving at PG-R1 for 10.1.3.1?
Which K value setting will be used to make sure that this link is not used by EIGRP when the link load reaches
You are a network technician at PassGuide.com, study the exhibit carefully. In this EIGRP network, the output of the command show interface for the link between PG-R2 and PG-R5 indicates that the link load varies between 10 and 35. Which K value setting will be used to make sure that this link is not used by EIGRP when the link load reaches 35, but can be used
again when the link load drops below 20?
which router will have originated it?
Based on the network provided in the exhibit, in these two areas, all routers are performing OSPF on all interfaces. After examining the OSPF database on PG-R4, do you know which type of LSA will contain 10.1.5.0/24, and which router will have originated it?
What would be the most probable reason for this port-ID mismatch?
Refer to the exhibit. Look at the command output. What would be the most probable reason for this port-ID mismatch?